How to Re-Waterproof Your Jacket

Views : 63
Update time : 2016-07-20 16:53:38

If you haven’t washed or treated your waterproof-breathable jacket, and it’s seen a few seasons of use, you’ve probably noticed that it doesn’t keep you as dry as it used to. One of the biggest misconceptions with waterproof jackets is that you should never wash them. If you don’t wash them, your jacket’s pores can clog and it will no longer be breathable. The oils from your skin can also lead to delamination in the liner of your jacket. There is a simple process for washing your jacket and revitalizing its waterproofing that will help you get more out of your jacket and help to extend its life for a few more seasons.

1.Take a look at your jacket.
 The first step in the process of getting your rain jacket ready for spring is to take a thorough look at it. Start with the inside. If the lining is peeling or bubbling and separating from the membrane, it’s time to retire your rain jacket. The next few steps will help to prevent this from happening to your new jacket.

2.Wash your jacket.
 One of the most widespread misconceptions when it comes to waterproof breathable jackets is that you should never wash them, but this couldn’t be farther from the truth. Washing your jacket on a regular basis is crucial to keeping it functioning properly and in good shape. Failing to wash your jacket allows for dirt and the oils from your skin to clog the pores of the jacket, leading to that clammy feeling inside the jacket and worse, delamination of the liner.

To wash your jacket, use a specially formulated detergent. We recommend Nikwax’s Tech Wash, though Granger also makes a suitable wash. Place your jacket in the washing machine. A good rule of thumb is one capful of detergent for each jacket. (In hard-water areas, Nikwax recommends adding an additional capful.) In a front-loading washing machine, make sure to remove any buildup in the detergent dispenser, then add the Tech Wash. For a top-loading washing machine, add the detergent once the machine has filled with water. Set the cycle to heavy (or synthetics if your machine has it) and warm water.

3.Wash your jacket again using TX Direct. After you have finished washing the jacket, wash it again following the same guidelines, this time using Nikwax’s TX Direct Wash-In. This will revitalize the waterproofing in your jacket’s membrane.

4.Dry the jacket.
 To dry your jacket, tumble dry it on low heat for no more than ten minutes. This will help to shake off most of the water and start the drying process. Take your jacket out of the dryer and hang dry it overnight.

5. Inspect your jacket for holes and tears. Look for any tears, pinholes, or abrasions in your jacket. If your jacket has a pinhole or tear, use Gear Aid’s Gore-Tex fabric patches to patch the hole. Cut the patch in either a circular or oval shape to reduce the chances of peeling. For a stronger bond, use an iron on its lowest possible setting for a few seconds on the patch to bond it to the jacket. (Be extremely careful using an iron. If the iron is too hot, it will melt your jacket.) For abrasions, use Gear Aid’s Tenacious Tape to cover the abraded areas. Again, cut the patches in circles or ovals to reduce the risk of peeling.

Related News
2017 HK Global Sorce Fashion--Asia Expo 2017 HK Global Sorce Fashion--Asia Expo
Jan .03.2018
We took part in 2017 HK Global Sorce Fashion Asia Expo. Our products is very popular and inquired by visitors oversea.
How to Buy a Waterproof Jacket How to Buy a Waterproof Jacket
Jul .18.2016
Tips for buying a waterproof jacket